Pretty Tight Kitty’s
Remote Control Therapeutic Wand

Product StructureProduct Structure

On/Off and Default Setting

Turn the base on first using the ON/OFF switch. After turning on the remote, it will start at the default medium level for all functions. Power down the rotation & vibration until they are both off. Turn on the heat with the RF+, and adjust the temperature with the T+ button, to high for a preheat of the device for 10 minutes before use. The REV button is for the rotation feature, Vib is for Vibration, and all are adjusted up or down with +&- for the low, medium, and high functions. Press the “-” button twice to turn off the device. Holding down the “-” button will keep the device in the off state. Be sure to turn the base off when not in use.

Left flower Right flower

Procedure Parameters and Directions of use

Our treatment parameters are to use the device twice a week for 4 weeks, then once a week for a month. From there on you should use the device as needed or desired or at least once every 6 months, but there is no reason you cannot use it as desired for pleasure also, or daily. You may even have sexual intercourse if you desire with a partner if there is no spotting or cramping, otherwise, abstain from sex for 24 hours.

Step 1: Prep, Positioning and Gel Application

  • IconPreheat the device for 10 minutes before inserting and starting the procedure.
  • IconStart by thoroughly cleansing your vaginal area with a mild, non-perfumed soap and warm water, pat the area dry with a clean, soft towel. Make sure to shave the external area first before use.
  • IconEnsure that you are in a private space where you can concentrate and follow the instructions without interruptions. Get comfortable and in a relaxed position, lying with your legs slightly apart and on a towel.
  • IconApply a small amount of unscented water soluble, toy safe personal gel or lubricant to the shaft of the device. Please don’t allow any gel or lubricant to run down onto the base unit as this may cause harm to the internal structure of the device. Never allow the device to sit idle internally or externally for any length of time to avoid overheating of your skin tissue.

Step 2: Internal Treatment

Vigina image
  • IconTurn the heat and rotation to the desired temperature and rotation speed of low, medium, or high. All settings are in a therapeutic heat range.
  • IconInsert the device shaft into the vaginal vault with a small amount of lubricant or gel. Prop it in place with a towel or small pillow against the base of the device. Then use the remote control to operate the many different functions. For your first treatment start in the low setting and advance as tolerated. Internal treatments are for 7-10 minutes.
  • IconOnce the internal treatment is done, remove the device holding the device by the base. Keep the heat on and adjust to low, medium, or high for the external treatment.

Step 3: External Treatment

Vigina image
  • IconBe sure to hold the device at the base when using externally, being careful not to hold onto the shaft with the heat on. Reapply a small amount of lubricant/gel to the shaft of the device again and place it on one side (right or left) of the external/internal labia with the rotation on low, medium, or high. You may use the vibration feature at low, medium, or high also as it may be used for distraction or pleasure. Be sure no fluid is running onto the device.
  • IconMove the device using the base up and down from the external introitus up to the clitoral hood where the urethra is also (see diagram), making sure the heat gets to this area also, and then go back down in an oblong circular motion for 3-5 minutes, then repeat on the other side, or even in the middle.
  • IconEnjoy the vibration to complete your experience without the heat or rotation on if desired. We encourage you to make the treatment as fun and enjoyable as you can, as pleasure is normal when treating internal and external areas of the vagina, so have a blast!
  • IconTurn off the device with the remote and at the base also and remove by holding the base.

Step 4: Post Treatment Device Care

  • IconBe sure to clean the device base and shaft with a warm sudsy washcloth and sanitation/disinfectant wipe. Recharge the device so it is charged for the next use. Store it in a safe place in the original box.

Frequently Asked Questions

What is a vaginal rejuvenation device ?

A vaginal rejuvenation device is a non-surgical tool designed to enhance vaginal aesthetics or function, often used for tightening or addressing post-childbirth/sexual and menopausal concerns.

Is the procedure painful ?

Pain levels vary. Some report mild discomfort during vaginal rejuvenation procedures, but this device is extremely comfortable to most users!. but anesthesia or topical numbing agents are often used to minimize pain and discomfort.

How long does a typical treatment session take ?

A typical vaginal rejuvenation session lasts around 15 to 30 minutes, depending on the specific procedure and individual needs. Multiple sessions may be recommended for optimal results.

Is there any downtime after the procedure ?

Downtime after vaginal rejuvenation varies. Some procedures may have minimal downtime, while others may require a few days for recovery. It depends on the treatment’s nature and intensity. There is no downtime with treatment with our devices.

Are there any risks or side effects ?

Vaginal Rejuvenation is 100% safe, non-invasive, requires no recovery time, and is pain-free.

Can I control the energy levels ?

Yes. The internal mode of Vaginal Rejuvenation has three energy levels.